Power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is developed exclusively for your small lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit has been widely utilised in the business of logistic gadgets including minifork lift, scissors lift and ariel working platforms. The lower-ing movement is managed through the solenoid valve using the pace managed by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Basic Description
This power unit is made exclusively for 
your medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve as well as the pace managed from the adjustable needle valve. Once the lift rises to a high positoin, but the energy provide is minimize, the lowering movement is managed through the manual override function.
Electrical power UNITS FOR LIFT TABLE 3
Standard Description
This energy unit is developed exclusively for your huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve and also the speed managed by a pressure compensated flow control valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This electrical power unit is created exclusively to the huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as the speed controlled from the adjustable needle valve. Once the lift rises to a high positoin, but the energy provide is lower, the lowering movement is managed from the manual override function.
Specific Notes
one. This electrical power unit is of S3 duty cycle, which might only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean all the hydraulic elements concerned just before set up of the electrical power unit.
3. Viscosity on the oil shoud be 15~46 cst,which ought to also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
four. Oil shifting is required following the initial a hundred operation hrs,afterwards after every single 3000 hrs.
5. The power unit shown is designed to be mounted vertically.
